Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

KOHLBERGER ELASTO-CRYL 131

NFPA

PRODUCT USE

A water reducible acrylic/bitumen membrane coating for use in underground mine workings or
tunnels. Requires that the two parts be mixed by hand or mixer before use, in accordance
with manufacturers directions. Mix only as much as is required. Do not return the mixed
material to the original containers. Apply by brush, hand roller or spray atomisation.

SYNONYMS

"bitumen acrylic WB water base membrane coating", "elasot-fort 131"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Although ingestion is not thought to produce harmful effects, the material may still be damaging to the health of the individual following ingestion, especially where pre-  existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally based on doses producing mortality (death) rather than those producing morbidity (disease, ill-health). Gastrointestinal tract discomfort may produce nausea and vomiting. In an occupational setting however, ingestion of insignificant quantities is not thought to be cause for concern.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, abdominal irritation, pain and vomiting.  

EYE

  There is some evidence to suggest that this material can causeeye irritation and damage in some persons.  The liquid may produce eye discomfort and is capable of causing temporary impairment of vision and/or transient eye inflammation, ulceration.  

SKIN

  The material is not thought to produce adverse health effects or skin irritation following contact (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable gloves be used in an occupational setting.  

INHALED

  The material is not thought to produce adverse health effects or irritation of the respiratory tract (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable control measures be used in an occupational setting.  Inhalation hazard is increased at higher temperatures.  Acrylic polymer emulsions may contain residual traces of odourous acrylic monomers; the amounts remaining in compounded mixtures represents a very low order of exposure, however this may become noticeable with some materials particularly in confined or poorly ventilated spaces.  

CHRONIC HEALTH EFFECTS

  Principal routes of exposure are usually by skin contact with the material and inhalation of vapor/spray mist.  Prolonged or repeated skin contact may cause drying with cracking,irritation and possible dermatitis following.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.