Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

JOTUN JOTACOTE UHB COMPONENT A

NFPA

PRODUCT USE

Component A or Base of a 2 pack epoxy coating system. Requires that the two parts be mixed
by hand or mixer before use, in accordance with manufacturers directions. Mix only as much
as is required. Do not return the mixed material to the original containers. The use of a
quantity of material in an unventilated or confined space may result in increased exposure
and an irritating atmosphere developing.Before starting consider control of exposure by
mechanical ventilation.

SYNONYMS

"Two pack epoxy solventless solvent less coating paint", UHB, "ultra high build"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

May cause SENSITIZATION by skin contact.
Harmful by inhalation, in contact with skin and if swallowed.
Irritating to eyes, respiratory system and skin.
Toxic to aquatic organisms, may cause long- term adverse effects in the aquatic
environment.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Accidental ingestion of the material may be harmful; animal experiments indicate that ingestion of less than 150 gram may be fatal or may produce serious damage to the health of the individual.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, pain, vomiting. Vomit entering the lungs by aspiration may cause potentially lethal chemical pneumonitis.  

EYE

  This material can cause eye irritation and damage in some persons.  The material may produce moderate eye irritation leading to inflammation. Repeated or prolonged exposure to irritants may produce conjunctivitis.  

SKIN

  Skin contact with the material may be harmful; systemic effects may resultfollowing absorption.  This material can cause inflammation of the skin oncontact in some persons.  Epoxy materials may cause allergic and/or contact dermatitis responses, which may occur on exposure or may become apparent only after repeated exposures. Sensitization is possible. Photoallergic dermatitis may result from contact with the material. This type of response can be elicited only in individuals who have been previously allergically sensitized to the chemical agent and appropriate radiation. Photoallergic dermatitis presents, clinically, as an eczematous dermatitis in sun-exposed areas.  Sensitization may result in allergic dermatitis responses includingrash, itching, hives or swelling of extremities.  The material may accentuate any pre-existing skin condition.  Open cuts, abraded or irritated skin should not be exposed to this material.  

INHALED

  If inhaled, this material can irritate the throat andlungs of some persons.  Not normally a hazard due to non-volatile nature of product.  Inhalation hazard is increased at higher temperatures.  Inhalation of vapor may result in nausea, headache.  Inhalation of vapor may aggravate a pre-existing respiratory condition such as asthma, bronchitis, emphysema.  Respiratory sensitization may result in allergic/asthma like responses; from coughing and minor breathing difficulties to bronchitis with wheezing, gasping.  

CHRONIC HEALTH EFFECTS

  Skin contact with the material is more likely to cause a sensitization reaction in some persons compared to the general population.  

  Principal routes of exposure are usually by skin contact with the material, inhalation of vapor, inhalation of vapor from the curing material.  Prolonged or repeated skin contact may cause drying with cracking,irritation and possible dermatitis following.  Sensitization reactions may appear suddenly after repeatedsymptom free exposures.  Sensitization may give severe responses to very low levels of exposure, i.e. hypersensitivity. Sensitized persons should not be allowed to work in situations where exposure may occur.