Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

UCB EBECRYL 1608

NFPA

PRODUCT USE

Reactive multifunctional monomer with low skin irritation for radiation, i.e. UV curing,
inks and coatings. Also used in emulsion polymers.

SYNONYMS

"acrylated oligomer", "purified epoxyacrylate in oligotriacrylate", Polychem

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Irritating to eyes, respiratory system and skin.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Although ingestion is not thought to produce harmful effects, the material may still be damaging to the health of the individual following ingestion, especially where pre-  existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally based on doses producing mortality (death) rather than those producing morbidity (disease, ill-health). Gastrointestinal tract discomfort may produce nausea and vomiting. In an occupational setting however, ingestion of insignificant quantities is not thought to be cause for concern.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, pain, vomiting. Vomit entering the lungs by aspiration may cause potentially lethal chemical pneumonitis.  

EYE

  This material can cause eye irritation and damage in some persons.  

SKIN

  This material can cause inflammation of the skin oncontact in some persons.  Skin contact is not thought to have harmful health effects, however the material may still produce health damage following entry through wounds, lesions or abrasions.  Bare unprotected skin should not be exposed to this material.  Toxic effects may result from skin absorption.  The material may accentuate any pre-existing skin condition.  All multifunctional acrylates (MFA) produce skin disorders and sensitize the skin and inflammation. Vapors generated by the heat of milling may occur in sufficient concentration to produce inflammation. Because exposure to industrial aerosols of MFA includes exposure to resin systems, photo- initiators, solvents, hydrogen-transfer agents,  stabilizers, surfactants, fillers and polymerization inhibitors, poisoning may arise due to a range of chemical actions.  

INHALED

  If inhaled, this material can irritate the throat andlungs of some persons.  Although inhalation is not thought to produce harmful effects, the material may still produce health damage, especially where pre-existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally confined to doses producing mortality (death) rather than those producing morbidity (disease, ill-  health).  Not normally a hazard due to non-volatile nature of product.  Inhalation hazard is increased at higher temperatures.  

CHRONIC HEALTH EFFECTS

  Principal routes of exposure are usually by skin contact/eye contact and inhalation of vapor.  Prolonged or continuous skin contact with the liquid may cause defatting with drying, cracking, irritation and dermatitis following.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.