Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

KINDT DYNOCAST B

NFPA

PRODUCT USE

Part B or Hardener of a 2 pack urethane coating system. Requires that the two parts be
mixed by hand or mixer before use, in accordance with manufacturers directions. Mix only
as much as is required. Do not return the mixed material to the original containers. Refer
also to protective measures for the other component used with the product. Read both MSDS
before using; store and attach MSDS together.

SYNONYMS

"polyether polyol resin", "polyurethane coating", "Dynocast Kit"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Although ingestion is not thought to produce harmful effects, the material may still be damaging to the health of the individual following ingestion, especially where pre-  existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally based on doses producing mortality (death) rather than those producing morbidity (disease, ill-health). Gastrointestinal tract discomfort may produce nausea and vomiting. In an occupational setting however, ingestion of insignificant quantities is not thought to be cause for concern.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, pain, vomiting. Vomit entering the lungs by aspiration may cause potentially lethal chemical pneumonitis.  

EYE

  There is some evidence to suggest that this material can causeeye irritation and damage in some persons.  The liquid may produce eye discomfort and is capable of causing temporary impairment of vision and/or transient eye inflammation, ulceration.  

SKIN

  The material is not thought to produce adverse health effects or skin irritation following contact (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable gloves be used in an occupational setting.  The liquid may produce skin discomfort following prolonged contact. Defatting and/or drying of the skin may lead to dermatitis.  Open cuts, abraded or irritated skin should not be exposed to this material.  The material may accentuate any pre-existing skin condition.  

INHALED

  The material is not thought to produce adverse health effects or irritation of the respiratory tract (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable control measures be used in an occupational setting.  Inhalation hazard is increased at higher temperatures.  Inhalation of high concentrations of gas/vapor causes lung irritation with coughing and nausea, central nervous depression with headache and dizziness, slowing of reflexes, fatigue and inco-ordination.  If exposure to highly concentrated solvent atmosphere is prolonged this may lead to narcosis, unconsciousness, even coma and possible death.  

CHRONIC HEALTH EFFECTS

  Principal routes of exposure are usually by inhalation of vapor/spray mist and skin contact with the liquid.  Prolonged or continuous skin contact with the liquid may cause defatting with drying, cracking, irritation and dermatitis following.  Chronic solvent inhalation exposures may result in nervous system impairment and liver and blood changes. [PATTYS].