Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WHITE KING FOR COLOURS MULTIPURPOSE STAIN REMOVER (POWDER)

NFPA

PRODUCT USE

Stain remover. Regeant

SYNONYMS

"stain remover"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Risk of serious damage to eyes.
May cause SENSITIZATION by inhalation and skin contact.
Harmful by inhalation and if swallowed.
Irritating to respiratory system and skin.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Accidental ingestion of the material may be harmful; animal experiments indicate that ingestion of less than 150 gram may be fatal or may produce serious damage to the health of the individual.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, abdominal irritation, pain and vomiting.  

EYE

  If applied to the eyes, this material causes severe eye damage.  There is evidence that material may produce eye irritation in some persons and produce eye damage 24 hours or more after instillation. Severe inflammation may be expected with pain. There may be damage to the cornea. Unless treatment is prompt and adequate there may be permanent loss of vision. Conjunctivitis can occur following repeated exposure.  Direct eye contact with some anionic surfactants in high concentration can cause severe damage to the cornea. Low concentrations can cause discomfort, excess blood flow, and corneal clouding and swelling. Recovery may take several days.  

SKIN

  This material can cause inflammation of the skin oncontact in some persons.  Entry into the blood-stream, through, for example, cuts, abrasions or lesions, may produce systemic injury with harmful effects. Examine the skin prior to the use of the material and ensure that any external damage is suitably protected.  The material may cause severe skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin. Repeated exposures may produce severe ulceration.  Anionic surfactants can cause skin redness and pain, as well as a rash. Cracking, scaling and blistering can occur.  

INHALED

  If inhaled, this material can irritate the throat andlungs of some persons.  Inhalation of dusts, generated by the material, during the course of normalhandling, may be harmful.  There is some evidence to suggest that this material can cause, if inhaled once, irreversible damage of organs.  Not normally a hazard due to non-volatile nature of product.  

CHRONIC HEALTH EFFECTS

  Long term exposure to high dust concentrations may cause changes in lung function i.e. pneumoconiosis; caused by particles less than 0.5 micron penetrating and remaining in the lung. Prime symptom is breathlessness; lung shadows show on X-ray.  Inhaling this product is more likely to cause a sensitization reaction in some persons compared to the general population.  There is limited evidence that, skin contact with this product is more likely to cause a sensitization reaction in some persons compared to the general population.  Chronic inhalation exposure may result in nasal ulceration and/orperforation of nasal septum.  Principal routes of exposure are by accidental skin and eye contact andinhalation of generated dusts.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.