Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WATTYL DIMET DIMETCOTE 9FT PART B

NFPA

PRODUCT USE

Part B of a two- part inorganic zinc coating used as a single- coat heavy duty primer in
severe weathering and marine environments, Application is usually by airless spray
atomisation. Requires that the two parts be mixed by hand or mixer before use, in
accordance with manufacturers directions. Mix only as much as is required. Do not return
the mixed material to the original containers.

SYNONYMS

"Zinc dust powder 2 pack zinc rich primer two pack", "inorganic zinc coating", paint,
"misspelling as dimetcoat dymetcote dymetcoat"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Contact with water liberates extremely flammable gases.
Spontaneously flammable in air.
Harmful if swallowed.
Irritating to eyes.
May cause fire.
Very toxic to aquatic organisms, may cause long- term adverse effects in the
aquatic environment.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Accidental ingestion of the material may be harmful; animal experiments indicate that ingestion of less than 150 gram may be fatal or may produce serious damage to the health of the individual.  Ingestion may result in nausea, abdominal irritation, pain and vomiting.  Considered an unlikely route of entry in commercial/industrial environments.  

EYE

  This material can cause eye irritation and damage in some persons.  Contact lenses can pose a special hazard. Soft lenses may absorb irritants and all contact lenses concentrate them. Removal of contact lenses after an eye injury should only be undertaken by skilled personnel.  

SKIN

  The material is not thought to produce adverse health effects or skin irritation following contact (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable gloves be used in an occupational setting.  The material may cause skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin.  

INHALED

  Inhalation may produce health damage*.  The material is not thought to produce respiratory irritation (as classified using animal models). Nevertheless inhalation of the material, especially for prolonged periods, may produce respiratory discomfort and occasionally, distress.  Not normally a hazard due to non-volatile nature of product.  

CHRONIC HEALTH EFFECTS

  Principal routes of exposure are usually by skin contact, eye contact and inhalation of generated dust.  Prolonged or repeated skin contact may cause drying with cracking,irritation and possible dermatitis following.  Welding or flame cutting of metals with zinc or zinc dust coatings may result in inhalation of zinc oxide fume; high concentrations of zinc oxide fume may result in "metal fume fever"; also known as "brass chills", an industrial disease of short duration. [I.L.O] Symptoms include malaise, fever, weakness, nausea and may appear quickly if operations occur in enclosed or poorly ventilated areas.