Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WATTYL ANTI-MOULD TREATMENT

NFPA

PRODUCT USE

Anti- fungal agent when diluted with water in the recommended ratios; for use on brick,
fibrous cement sheeting, paper- faced plaster board, timber, etc. Generally applied by
brush.

SYNONYMS

"disinfectant cleaner anti-fungal agent", "anti-mould solution", Fungisol

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Irritating to eyes and skin.
Toxic to aquatic organisms.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Although ingestion is not thought to produce harmful effects, the material may still be damaging to the health of the individual following ingestion, especially where pre-  existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally based on doses producing mortality (death) rather than those producing morbidity (disease, ill-health). Gastrointestinal tract discomfort may produce nausea and vomiting. In an occupational setting however, ingestion of insignificant quantities is not thought to be cause for concern.  Considered an unlikely route of entry in commercial/industrial environments.  

EYE

  This material can cause eye irritation and damage in some persons.  

SKIN

  This material can cause inflammation of the skin oncontact in some persons.  Skin contact is not thought to have harmful health effects, however the material may still produce health damage following entry through wounds, lesions or abrasions.  Toxic effects may result from skin absorption.  

INHALED

  The material is not thought to produce adverse health effects or irritation of the respiratory tract (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable control measures be used in an occupational setting.  Not normally a hazard due to non-volatile nature of product.  

CHRONIC HEALTH EFFECTS

  There is some evidence that inhaling this product is more likely to cause a sensitization reaction in some persons compared to the general population.  

  Principal routes of exposure are by accidental skin and eye contact and by inhalation of vapors especially at higher temperatures.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.