Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

K&H AFI OAK

NFPA

PRODUCT USE

Used for the general repairs of metal, masonry, wooden and fibreglass surfaces.

SYNONYMS

AFIC-25, "polyester putty"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Limited evidence of a carcinogenic effect.
HARMFUL - May cause lung damage if swallowed.
Harmful by inhalation and if swallowed.
Irritating to eyes and skin.
Flammable.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Accidental ingestion of the material may be harmful; animal experiments indicate that ingestion of less than 150 gram may be fatal or may produce serious damage to the health of the individual.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, pain, vomiting. Vomit entering the lungs by aspiration may cause potentially lethal chemical pneumonitis.  

EYE

  This material can cause eye irritation and damage in some persons.  The material may produce severe irritation to the eye causing pronounced inflammation. Repeated or prolonged exposure to irritants may produce conjunctivitis.  

SKIN

  This material can cause inflammation of the skin oncontact in some persons.  Skin contact is not thought to have harmful health effects, however the material may still produce health damage following entry through wounds, lesions or abrasions.  Toxic effects may result from skin absorption.  The material may cause skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin.  

INHALED

  The material is not thought to produce respiratory irritation (as classified using animal models). Nevertheless inhalation of the material, especially for prolonged periods, may produce respiratory discomfort and occasionally, distress.  Inhalation hazard is increased at higher temperatures.  Acute effects from inhalation of high vapor concentrations may be chest and nasal irritation with coughing, sneezing, headache and even nausea.  

CHRONIC HEALTH EFFECTS

  There has been concern that this material can cause cancer or mutations, but there is not enough data to make an assessment.  

  Principal routes of exposure are usually by inhalation of vapor, inhalation of vapor/spray mist and skin contact with the material.  Prolonged or repeated skin contact may cause drying with cracking,irritation and possible dermatitis following.  Exposure to styrene may aggravate CNS disorders, chronic respiratory  disease, skin disease, kidney disease and liver disease.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.