Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

KOCH MARMORIT S45 LV *******OBSOLETE*******

NFPA

PRODUCT USE

Component A or Base of 2 Part epoxy floor topping, epoxy adhesive. Requires that the two
parts be mixed by hand or mixer before use, in accordance with manufacturers directions.
Mix only as much as is required. Do not return the mixed material to the original
containers. Applied using a hand trowel or spreader.

SYNONYMS

"2 part Epoxy adhesive solvent free liquid flooring Base Part A"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Although ingestion is not thought to produce harmful effects, the material may still be damaging to the health of the individual following ingestion, especially where pre-  existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally based on doses producing mortality (death) rather than those producing morbidity (disease, ill-health). Gastrointestinal tract discomfort may produce nausea and vomiting. In an occupational setting however, ingestion of insignificant quantities is not thought to be cause for concern.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, abdominal irritation, pain and vomiting.  

EYE

  There is some evidence to suggest that this material can causeeye irritation and damage in some persons.  The liquid may produce eye discomfort and is capable of causing temporary impairment of vision and/or transient eye inflammation, ulceration.  

SKIN

  The material is not thought to produce adverse health effects or skin irritation following contact (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable gloves be used in an occupational setting.  Epoxy materials may cause allergic and/or contact dermatitis responses, which may occur on exposure or may become apparent only after repeated exposures. Sensitization is possible. Photoallergic dermatitis may result from contact with the material. This type of response can be elicited only in individuals who have been previously allergically sensitized to the chemical agent and appropriate radiation. Photoallergic dermatitis presents, clinically, as an eczematous dermatitis in sun-exposed areas.  Sensitization may result in allergic dermatitis responses includingrash, itching, hives or swelling of extremities.  Sensitization reactions may appear suddenly after repeatedsymptom free exposures.  Open cuts, abraded or irritated skin should not be exposed to this material.  The material may accentuate any pre-existing skin condition.  

INHALED

  The material is not thought to produce adverse health effects or irritation of the respiratory tract (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable control measures be used in an occupational setting.  Not normally a hazard due to non-volatile nature of product.  Inhalation hazard is increased at higher temperatures.  Inhalation of vapor may result in nausea, headache.  

CHRONIC HEALTH EFFECTS

  There is some evidence that inhaling this product is more likely to cause a sensitization reaction in some persons compared to the general population.  

  Primary route of exposure is usually by skin contact with the material and inhalation of vapor from the curing material.  Prolonged or repeated skin contact may cause drying with cracking,irritation and possible dermatitis following.  Sensitization may give severe responses to very low levels of exposure, i.e. hypersensitivity. Sensitized persons should not be allowed to work in situations where exposure may occur.