Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WELDWELL 509 FLUX (AL 329)

NFPA

PRODUCT USE

Aluminium soldering flux.

SYNONYMS

"aluminium soldering flux", "alsolder flux", AL329

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

Causes burns.
Risk of serious damage to eyes.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  The material can produce chemical burns within the oral cavity and gastrointestinal tract following ingestion.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion of amine epoxy-curing agents (hardeners) may cause severe abdominal pain, nausea, vomiting or diarrhea. The vomitus may contain blood and mucous. If death does not occur within 24 hours there may be an improvement in the patients condition for 2-4 days only to be followed by the sudden onset of abdominal pain, boardlike abdominal rigidity or hypo- tension; this indicates that delayed gastric or esophageal corrosive damage has occurred.  

EYE

  The material can produce chemical burns to the eye following direct contact. Vapors or mists may be extremely irritating.  If applied to the eyes, this material causes severe eye damage.  Vapors of volatile amines irritate the eyes, causing excessive secretion of tears, inflammation of the conjunctiva and slight swelling of the cornea, resulting in "halos" around lights. This effect is temporary, lasting only for a few hours. However this condition can reduce the efficiency of undertaking skilled tasks, such as driving a car. Direct eye contact with liquid volatile amines may produce eye damage, permanent for the lighter species.  The material may produce moderate eye irritation leading to inflammation. Repeated or prolonged exposure to irritants may produce conjunctivitis.  

SKIN

  The material can produce chemical burns following direct contactwith the skin.  Many amine compounds are sensitizers and some are absorbed through intactskin.  The material may cause skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin.  

INHALED

  If inhaled, this material can irritate the throat andlungs of some persons.  Not normally a hazard due to non-volatile nature of product.  Inhalation of quantities of liquid mist may be extremely hazardous, even lethal due to spasm, extreme irritation of larynx and bronchi, chemical pneumonitis and pulmonary edema.  The material may produce respiratory tract irritation, and result in damage to the lung including reduced lung function.  

CHRONIC HEALTH EFFECTS

  Principal routes of exposure are by accidental skin and eye contact and by inhalation of vapors especially at higher temperatures.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.