Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WATTYL SIGMAGUARD CSF85 BASE

NFPA

PRODUCT USE

Specialist two pack epoxy coating for wine tanks. · Material is mixed and used in
accordance with manufacturers directions. Curing table must be closely observed for all
potable applications. Part A or Base of a 2 pack epoxy coating system. Requires that the
two parts be mixed by hand or mixer before use, in accordance with manufacturers
directions. Mix only as much as is required. Do not return the mixed material to the
original containers. Application is usually by airless spray atomisation. Requirements of
State Authorities concerning conditions for tank entry must be met. Particularly with
regard to training of crews for tank entry; work permits; sampling of atmosphere;
provision of rescue harness and protective gear as needed.

SYNONYMS

"epoxy potable internal tank coating system part a", paint

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

May cause SENSITIZATION by skin contact.
Irritating to eyes and skin.
Toxic to aquatic organisms, may cause long- term adverse effects in the aquatic
environment.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Although ingestion is not thought to produce harmful effects, the material may still be damaging to the health of the individual following ingestion, especially where pre-  existing organ (e.g. liver, kidney) damage is evident. Present definitions of harmful or toxic substances are generally based on doses producing mortality (death) rather than those producing morbidity (disease, ill-health). Gastrointestinal tract discomfort may produce nausea and vomiting. In an occupational setting however, ingestion of insignificant quantities is not thought to be cause for concern.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, abdominal irritation, pain and vomiting.  

EYE

  This material can cause eye irritation and damage in some persons.  The material may produce moderate eye irritation leading to inflammation. Repeated or prolonged exposure to irritants may produce conjunctivitis.  

SKIN

  This material can cause inflammation of the skin oncontact in some persons.  Skin contact is not thought to have harmful health effects, however the material may still produce health damage following entry through wounds, lesions or abrasions.  Open cuts, abraded or irritated skin should not be exposed to this material.  Epoxy materials may cause allergic and/or contact dermatitis responses, which may occur on exposure or may become apparent only after repeated exposures. Sensitization is possible. Photoallergic dermatitis may result from contact with the material. This type of response can be elicited only in individuals who have been previously allergically sensitized to the chemical agent and appropriate radiation. Photoallergic dermatitis presents, clinically, as an eczematous dermatitis in sun-exposed areas.  The material may accentuate any pre-existing dermatitis condition.  

INHALED

  The material is not thought to produce adverse health effects or irritation of the respiratory tract (as classified using animal models). Nevertheless, good hygiene practice requires that exposure be kept to a minimum and that suitable control measures be used in an occupational setting.  Not normally a hazard due to non-volatile nature of product.  Inhalation hazard is increased at higher temperatures.  

CHRONIC HEALTH EFFECTS

  Skin contact with the material is more likely to cause a sensitization reaction in some persons compared to the general population.  

  Principal routes of exposure are usually by skin contact with the material and inhalation of vapor from the curing material.  Prolonged or continuous skin contact with the liquid may cause defatting with drying, cracking, irritation and dermatitis following.  Sensitization reactions may appear suddenly after repeatedsymptom free exposures.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.  One ingredient of the product has caused skin sensitization reactions, shown as localized reddening and hives, or may produce respiratory sensitization characterized by asthma-  like symptoms and runny nose.