Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WATTYL SIGMA CSF BASE - PART A

NFPA

PRODUCT USE

Part A or Base of a 2 pack epoxy coating system. Requires that the two parts be mixed by
hand or mixer before use, in accordance with manufacturers directions. Mix only as much as
is required. Do not return the mixed material to the original containers. Application is
usually by spray atomisation. The use of a quantity of material in an unventilated or
confined space may result in increased exposure and an irritating atmosphere developing.

SYNONYMS

"epoxy based coating system part a", paint

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

May cause SENSITIZATION by skin contact.
Harmful by inhalation, in contact with skin and if swallowed.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  Accidental ingestion of the material may be harmful; animal experiments indicate that ingestion of less than 150 gram may be fatal or may produce serious damage to the health of the individual.  Considered an unlikely route of entry in commercial/industrial environments.  Ingestion may result in nausea, abdominal irritation, pain and vomiting.  

EYE

  Although the material is not thought to be an irritant, direct contact with the eye may produce transient discomfort characterized by tearing or conjunctival redness (as with windburn).  

SKIN

  Skin contact with the material may be harmful; systemic effects may resultfollowing absorption.  The material is not thought to be a skin irritant (as classified using animal models). Temporary discomfort, however, may result from prolonged dermal exposures. Good hygiene practice requires that exposure be kept to a minimum and that suitable gloves be used in an occupational setting.  Open cuts, abraded or irritated skin should not be exposed to this material.  Epoxy materials may cause allergic and/or contact dermatitis responses, which may occur on exposure or may become apparent only after repeated exposures. Sensitization is possible. Photoallergic dermatitis may result from contact with the material. This type of response can be elicited only in individuals who have been previously allergically sensitized to the chemical agent and appropriate radiation. Photoallergic dermatitis presents, clinically, as an eczematous dermatitis in sun-exposed areas.  The material may accentuate any pre-existing dermatitis condition.  

INHALED

  The material is not thought to produce respiratory irritation (as classified using animal models). Nevertheless inhalation of the material, especially for prolonged periods, may produce respiratory discomfort and occasionally, distress.  Not normally a hazard due to non-volatile nature of product.  Inhalation hazard is increased at higher temperatures.  

CHRONIC HEALTH EFFECTS

  Skin contact with the material is more likely to cause a sensitization reaction in some persons compared to the general population.  

  Principal routes of exposure are usually by skin contact with the material and inhalation of vapor from the curing material.  Prolonged or continuous skin contact with the liquid may cause defatting with drying, cracking, irritation and dermatitis following.  Sensitization reactions may appear suddenly after repeatedsymptom free exposures.  As with any chemical product, contact with unprotected bare skin; inhalation of vapor, mist or dust in work place atmosphere; or ingestion in any form, should be avoided by observing good occupational work practice.  One ingredient of the product has caused skin sensitization reactions, shown as localized reddening and hives, or may produce respiratory sensitization characterized by asthma-  like symptoms and runny nose.