Section 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME

WATTYL SIGMA HULLRITE BLACK PART A

NFPA

PRODUCT USE

Requires that the two parts be mixed by hand or mixer before use, in accordance with
manufacturers directions. Mix only as much as is required. Do not return the mixed
material to the original containers. The use of a quantity of material in an unventilated
or confined space may result in increased exposure and an irritating atmosphere
developing.Before starting consider control of exposure by mechanical ventilation. Part A
or base component of a two- part epoxy coating system for use on marine craft

SYNONYMS

"boat coating paint epoxy system"

Section 2 - HAZARDS IDENTIFICATION

CANADIAN WHMIS SYMBOLS

EMERGENCY OVERVIEW

RISK

May cause SENSITIZATION by skin contact.
HARMFUL - May cause lung damage if swallowed.
Harmful by inhalation and in contact with skin.
Irritating to eyes and skin.
Flammable.
Harmful to aquatic organisms, may cause long- term adverse effects in the
aquatic environment.

POTENTIAL HEALTH EFFECTS

ACUTE HEALTH EFFECTS

SWALLOWED

  The material is not thought to produce adverse health effects following ingestion (as classified using animal models). Nevertheless, adverse systemic effects have been produced following exposure of animals by at least one other route and good hygiene practice requires that exposure be kept to a minimum.  

EYE

  There is evidence that material may produce eye irritation in some persons and produce eye damage 24 hours or more after instillation. Severe inflammation may be expected with pain. There may be damage to the cornea. Unless treatment is prompt and adequate there may be permanent loss of vision. Conjunctivitis can occur following repeated exposure.  

SKIN

  Skin contact with the material may be harmful; systemic effects may resultfollowing absorption.  The material may cause moderate inflammation of the skin either following direct contact or after a delay of some time. Repeated exposure can cause contact dermatitis which is characterized by redness, swelling and blistering.  Entry into the blood-stream, through, for example, cuts, abrasions or lesions, may produce systemic injury with harmful effects. Examine the skin prior to the use of the material and ensure that any external damage is suitably protected.  Exposure limits with "skin" notation indicate that vapor and liquid may be absorbed through intact skin. Absorption by skin may readily exceed vapor inhalation exposure. Symptoms for skin absorption are the same as for inhalation. Contact with eyes and mucous membranes may also contribute to overall exposure and may also invalidate the exposure standard.  The material may cause skin irritation after prolonged or repeated exposure and may produce on contact skin redness, swelling, the production of vesicles, scaling and thickening of the skin.  

INHALED

  Inhalation of vapors or aerosols (mists, fumes), generated by the material during the course of normal handling, may be harmful.  There is some evidence to suggest that the material can cause respiratory irritation in some persons. The body's response to such irritation can cause further lung damage.  If exposure to highly concentrated solvent atmosphere is prolonged this may lead to narcosis, unconsciousness, even coma and possible death.  Headache, fatigue, lassitude, irritability and gastrointestinal disturbances (e.g., nausea, anorexia and flatulence) are the most common symptoms of xylene overexposure. Injury to the heart, liver, kidneys and nervous system has also been noted amongst workers. Transient memory loss, renal impairment, temporary confusion and some evidence of disturbance of liver function was reported in three workers overcome by gross exposure to xylene (10000 ppm). One worker died and autopsy revealed pulmonary congestion, oedema and focal alveolar haemorrhage. Volunteers inhaling xylene at 100 ppm for 5 to 6 hours showed changes in manual coordination reaction time and slight ataxia. Tolerance developed during the workweek but was lost over the weekend. Physical exercise may antagonise this effect. Xylene body burden in humans exposed to 100 or 200 ppm xylene in air depends on the amount of body fat with 4% to 8% of total absorbed xylene accumulating in adipose tissue.  

CHRONIC HEALTH EFFECTS

  Limited evidence suggests that repeated or long-term occupational exposure may produce cumulative health effects involving organs or biochemical systems.  There has been some concern that this material can cause cancer or mutations but there is not enough data to make an assessment.  There is some evidence that inhaling this product is more likely to cause a sensitization reaction in some persons compared to the general population.  Skin contact with the material is more likely to cause a sensitization reaction in some persons compared to the general population.  There is some evidence that human exposure to the material may result in developmental toxicity. This evidence is based on animal studies where effects have been observed in the absence of marked maternal toxicity, or at around the same dose levels as other toxic effects but which are not secondary non-specific consequences of the other toxic effects.  Exposure to the material for prolonged periods may cause physical defects in the developing embryo (teratogenesis).  Sensitization may give severe responses to very low levels of exposure, i.e. hypersensitivity. Sensitized persons should not be allowed to work in situations where exposure may occur.  Bisphenol A may have effects similar to female sex hormones and when administered to pregnant women, may damage the fetus. It may also damage male reproductive organs and sperm.